Replacement Steel Needles For Flooring Wall Tile Leveling System
SKU #6954572447780
Typ: Masonry Brick Tools
Dostupnost: Na skladě
Ceny od: $ 27.59
DOPRAVA DOPRAVA ZDARMA NA CELÉM SVĚTĚ
FEATURES:
Wear-resistant, recyclable.
Easy to use in DIY operation.
Balance tiles in the same horizontal position.
Improve the installation speed of tile.
Reduce the fatigue/pressure of installers.
There is hardly any crackless, flat surface.
It reduces the need for grinding and polishing.
Prevent tiles from moving during solidification.
SPECIFICATIONS:
Material:
stainless steel
Length of steel needle:
32mm/1.26"
Thickness of steel needle:
about 1.5mm
Type:100pcs Steel Needles
Use Tips:
Lay the first tile, leaving more than 2mm (with cross gaskets). Close to tile.
Insert T-pins along the gap between tiles.
Then rotate 180 degrees and the T-needle is stuck at the bottom of the two tiles.
Adjust the lid with a hand/special wrench until the two tiles are on the same level.
After leveling, about 5-6 hours, before the cement/binder is completely dry, rotate the lid in reverse and take out the 180 degree T needle until the word is removed.
Avoid not removing the T-tile leveling system:
1. Ceramic tile gaskets are 2mm or more (cross gaskets are recommended)
2. When leveling, the cement or tile adhesives around T-type leveller must be cleaned.
3. Remove the T-type straightener about 5-6 hours after leveling before the tile binder or cement is completely dried.
INCLUDES:
100 X Steel Needles
Produkt neodpovídá popisu? Kontaktujte nás do 30 dnů po obdržení!
V případě zrušení budou peníze vráceny na váš účet do 3 dnů.
Wear-resistant, recyclable.
Easy to use in DIY operation.
Balance tiles in the same horizontal position.
Improve the installation speed of tile.
Reduce the fatigue/pressure of installers.
There is hardly any crackless, flat surface.
It reduces the need for grinding and polishing.
Prevent tiles from moving during solidification.
SPECIFICATIONS:
Material:
stainless steel
Length of steel needle:
32mm/1.26"
Thickness of steel needle:
about 1.5mm
Type:100pcs Steel Needles
Use Tips:
Lay the first tile, leaving more than 2mm (with cross gaskets). Close to tile.
Insert T-pins along the gap between tiles.
Then rotate 180 degrees and the T-needle is stuck at the bottom of the two tiles.
Adjust the lid with a hand/special wrench until the two tiles are on the same level.
After leveling, about 5-6 hours, before the cement/binder is completely dry, rotate the lid in reverse and take out the 180 degree T needle until the word is removed.
Avoid not removing the T-tile leveling system:
1. Ceramic tile gaskets are 2mm or more (cross gaskets are recommended)
2. When leveling, the cement or tile adhesives around T-type leveller must be cleaned.
3. Remove the T-type straightener about 5-6 hours after leveling before the tile binder or cement is completely dried.
INCLUDES:
100 X Steel Needles
ZÁRUKA
Pokud položka nebyla doručena do 40 dnů po zakoupení, vrátíme vám peníze. Na vrácení peněz máte 2 týdny - do 60. dne.Produkt neodpovídá popisu? Kontaktujte nás do 30 dnů po obdržení!
V případě zrušení budou peníze vráceny na váš účet do 3 dnů.